Ontario Bus Driver Test 08

It would be best to dedicate enough time to study and prepare for the test. Luckily, there are various resources and study materials available that cater to the specific requirements of the Ontario bus driver practice test. So, whether you’re an experienced driver or new to the industry, use these tools to increase your chances of success.

Ontario Bus Test 08

1 / 30

Is it required to inspect the steps and floor?

Only if the bus is older

Yes

If your employer asks you to

2 / 30

The glass surface of any mirror is a defect if it does not have a non-reflective area of more than...

7.5 square cm

6.5 square cm

5 square cm

4.5 square cm

3 / 30

When passengers have entered the bus, what should you see before moving the vehicle once again?

That all passengers have seated safely

All of the above

That the students are all quiet to avoid distracting you

That all belongings are on the floor beside the aisle

4 / 30

Which statement is false? The following are locations that are not suitable for making a lane change, including...

Solid pavement markings

Areas with a broken white line

Railway crossings

Pedestrian crossings

5 / 30

At what speed should backing always be done?

20 km/h

Barely moving

Walking speed

None of the above

6 / 30

For a manual transmission vehicle why should you run the engine in the highest gear range?

To save on brakes

To help keep it in low revs

All of the above

To give it more power

7 / 30

What could happen if you license plate is not visible?

You could be fined

Your driver's license is suspended

The vehicle can be taken out of service

None of the above

8 / 30

Which of the following is not a defect when the Emergency equipment is...

Doesn't work properly

Damaged

The wrong size

Missing

9 / 30

Which statement is false? You should you turn off your engine when you stop for any length of time, other than when loading or unloading passengers...

Prevents unnecessary emissions

Keeps the bus hidden

Reduce maintenance requirements

Save fuel

10 / 30

Which of the following is not a defect if the wiper blade is...

Damaged

Wrong size

Fails to adequately clear driver's field of vision

Missing

11 / 30

What's the purpose of stopping with enough space between your vehicle and the vehicle ahead?

So as not to hit that vehicle

It's the law

All of the above

It allows you to be able to manoeuvre the vehicle if necessary

12 / 30

What kind of defect is it when the stanchion padding is damaged?

It's not

Minor

Major

Just clean it up

13 / 30

While exiting the expressway, where should you slow down?

Half way down the exit lane

One km before the exit lane

The exit lane

Prior to entering the exit lane

14 / 30

Why should you back off the accelerator when going down a hill?

It helps to slow down

To let gravity and momentum do the work

All of the above

Saves brakes

15 / 30

Which of the following is not an advantage of having a proper warm-up?

It reduces wear

It warms up the brake lines

It reduces leakage

It helps lubricate components and seals

16 / 30

When performing a lane change, you should operate within how much of the posted speed limit if conditions permit?

10 km/h

5 km/h over the limit

15 km/h

10 km/h over the limit

17 / 30

Which of the following is not a defect regarding the seat back or passenger-protection barrier padding?

Too much

Missing

Partially missing

Shifted from position so as not to be effective

18 / 30

When the seat is damaged or won't stay in the position needed to drive, what problem does this pose?

None of the above

The vehicle is placed out of service

A major defect

A minor defect

19 / 30

What's the problem with taking too much time to perform a lane change?

It allows the traffic patterns to change during the lane change

It slows down the vehicle

You may forget what you were doing

All of the above

20 / 30

How long should you typically let your vehicle warm up?

10 minutes

3 to 5 minutes

30 seconds

60 seconds

21 / 30

While stopped, where should you continue to look?

All of the above

The interior mirrors to watch the passengers

The dashboard

Traffic ahead, beside and in the vehicle mirrors

22 / 30

What happens if the student safety crossing arm is missing?

Tell your passengers to be careful

Let your employer know

Report it as a minor defect

All of the above

23 / 30

Which statement is false? While inspecting the windshield, what would you be looking for?

It has streaks

It has no damage to the glass

It is clear

It has no obstructions

24 / 30

When going through an intersection, when should any necessary transmission shifts be made?

During the first half of the intersection

None of the above

Prior to entering an intersection

During the last half of the intersection

25 / 30

What kind of a defect is it when the passenger seat is occupied and the seat is insecure?

Just ask the passenger to move

It's not a defect

Major

Minor

26 / 30

Why should you check the mirrors after clearing an intersection?

All of the above

It allows you to be continually aware of conditions so that necessary adjustments in speed and position can be made

To look for a space to change lane in the intersection

To ensure the mirrors are still operational

27 / 30

Are first aid kits required to always be complete?

Only on larger buses

Not if the driver is properly trained in first aid

Yes

28 / 30

Which of the following is not a minor defect with regards to the stop arm for a Class B and E vehicle?

Stop arm or stop sign is damaged so as to significantly affect visibility

Either light on stop arm is inoperative

Stop arm or stop sign is missing

Stop arm will only extend fully

29 / 30

Practise progressive gear shifting at approximately how many rpm?

2100 rpm

1200 rpm

1600 rpm

900 rpm

30 / 30

How long should you let your vehicle warm up if the temperature is below 0 degrees Celsius?

7 to 10 minutes

30 seconds

60 seconds

3 to 5 minutes

Your score is

Ontario Bus Driver Test 08

About

Practice Tests

Getting a License

Get In Touch