BC Commercial Driver Test 04

It is essential to remain calm and focused when taking the official exam. Pace yourself and take your time on each question, and don’t be afraid to ask for clarification if you’re unsure about a particular item. By passing the exam with flying colors, you’ll earn your commercial driver’s license and gain valuable skills and knowledge that will help you succeed on the road. So, take advantage of the resources and support available, and work hard to achieve your goals!

1 / 30

When transporting livestock and you have less than a full load, what can you do to keep livestock bunched together?

None of the above

Use false bulkheads

Use tiedowns

Rope off a section

2 / 30

Where a tiedown could be cut or scraped where it contacts cargo, what should be used to prevent this?

Metal clamps

Edge protectors

Rubber booties

Additional straps

3 / 30

Which statement is false? When you use load binders, you must...

Always check any tiedown assembly that's worn beyond a wear limitation embossed by the manufacturer or is unsafe after every 150 km travelled

Protect all tiedown assemblies from abrasion

Make sure your tiedown assemblies are strong enough

Ensure you can tighten all tiedowns unless steel, fiber or synthetic strapping is used

4 / 30

If your vehicle becomes disabled, park as far off the road as possible and place warning devices in front and behind the vehicle, but how far?

30 m ahead and 30 m behind the vehicle

60 m ahead and 60 m behind the vehicle

75 m ahead and 75 m behind the vehicle

50 m ahead and 50 m behind the vehicle

5 / 30

Loads on a straight truck can't extend how far beyond the turn centre without having a red flag attached?

No more than 3 metres

No more than 1 metre

No more than 2 metres

No more than 4 metres

6 / 30

Which statement is false? Police can impound the vehicle you're driving if you're caught committing any of the following offences, such as...

Street racing or stunt driving

Driving while suspended or prohibited

Excessive speeding (20 km/h or more over the posted limit)

Driving while unlicensed

7 / 30

Which statement is false? Tiedowns must not be used for cargo securement if...

Wire cable has missing strands or wraps

The chain has cracked welds or links

There are knots in any portion of chain, wire rope or webbing

The chain has been correctly repaired

8 / 30

When loading cargo, how should it be loaded so it doesn't cause your trailer to lean?

As close to the centre of your rig as possible

Closer to the rear of the rig

It doesn't matter as long as it's secured

Closer to the front of the rig

9 / 30

When coupling and uncoupling multiple trailers, if the trailers have spring brakes, what should you do before coupling?

Block the wheels

Ensure the vehicle is in neutral

Make sure the spring brakes are applied

Nothing

10 / 30

Which statement is false? Whipping and swerving may be caused by...

Improper trailer connections

Proper tire pressure

Shifting loads

Driving too fast for the conditions

11 / 30

Before a vehicle transporting logs enters a highway from a private road, what must the driver do first?

Weigh their load

None of the above

Inspect the vehicle, the logs and the securing devices to ensure compliance

Measure the logs

12 / 30

Front-end structures less than 1.83 m in height must be able to withstand a static load of how much?

At least 50 per cent of the total cargo weight uniformly distributed over the front-end structure

At least 25 per cent of the total cargo weight uniformly distributed over the front-end structure

At least 30 per cent of the total cargo weight uniformly distributed over the front-end structure

At least 75 per cent of the total cargo weight uniformly distributed over the front-end structure

13 / 30

What type of hitch is used to couple a truck and trailer?

I fifth wheel

A ball hitch

No hitch, just chains

A pintle hitch

14 / 30

How far in front of the vehicle can load extend?

1.5 metres

2 metres

1 metre

They can't extend

15 / 30

What percentage of all greenhouse gases are produced by vehicles?

15%

30%

10%

20%

16 / 30

What should the working load limit of tiedowns used to secure cargo be?

at least 50 per cent of the cargo weight.

At least 25 per cent of the cargo weight

At least 75 per cent of the cargo weight

At least 90 per cent of the cargo weight

17 / 30

If you're going to work with dangerous goods, what must your current employer do first?

Inspect the tractor

Certify that you've had appropriate training

Inspect the load

Nothing

18 / 30

Is a trip inspection report required for every new trailer you pick up each day?

No, unless it is loaded ahead of time

Yes

Not unless you're taking it onto the highway

19 / 30

A trailer with a high centre of gravity, what does it increase the chance of the vehicle doing?

Rolling over

Longer stopping distances

Poor fuel economy

Fishtailing

20 / 30

The Standard outlines specific requirements for transporting coils of rolled sheet metal where the shipment of coils weigh how much?

3968 kg or more

2,268 kg or more

4600 kg or more

1866 kg or less

21 / 30

Which statement is false? What is the advantage of turning the engine off when you're not driving (for example, at a truck stop or depot)

it will run better

none of the above

it has no advantages

It is more economical

22 / 30

What is referred to as dunnage?

Straps attached to the winch

Spacing blocks, boards and mats that separate cargo from itself and its restraints

Blocks to use to ensure the wheels don't move after parking the trailer

Straps attached to the anchor points

23 / 30

When towing two trailers, what risk do you face?

A slide

Locked wheels

None of the above

A jackknife or rollover

24 / 30

Is a cab shield (cab protector, bulkhead) considered a front-end structure or part of a cargo securement?

Yes

Yes, but only for light loads

No, it is not

Yes, but only for short loads

25 / 30

What should be the minimum distance between your breastbone and the airbag unit in the steering wheel?

A minimum of 15 cm

A minimum of 35 cm

A minimum of 25 cm

A minimum of 10 cm

26 / 30

When coupling a trailer to the tractor, how do you know they are lined up correctly?

You will hear a click

You will have to get out of the cab multiple times to check

You should be able to see an equal portion of each side of the trailer in each mirror

You will feel it

27 / 30

For trailers equipped with air suspension, what has to happen before applying the trailer brakes when leaving the trailer parked?

The wheels should be chocked

None of the above

The air suspension should be drained

More air should be added

28 / 30

If your trailer whips or swerves, what should you do to control it?

Stay to the right until the trailer stops whipping or swerving

Slow down and stop as soon as it's safe

None of the above

Tap the gas to straighten the trailer

29 / 30

When loading the trailer, why should the load be partially over or just ahead of the rear axles?

None of the above

To shorten braking distance

To save the front tires

To get proper tire loading

30 / 30

What does TAC stand for?

Transportation Aerodynamics Contribution

Transporting of Animal Cargo

Transportation Association of Canada

Transportation Administration of Canada

Your score is

BC Commercial Driver Test 04

About

Practice Tests

Getting a License

Get In Touch