Alberta Air Brake Test 07

Taking the Alberta Air Brake practice test proved to be instrumental in successfully passing the official exam with flying colors. The practice test, available online, offered valuable insights into the various aspects of air brake systems, including important safety guidelines, and provided an opportunity to familiarize oneself with the layout and structure of the actual exam.

1 / 30

What is not an in-service brake check?

Check air pressure gauges

Check dash to see if the low air pressure warning indicator is on

Be aware of brake system response when brakes are applied

Listening for any sounds during brake application

2 / 30

When is the air system checked for leaks during the pre-trip inspection?

After hearing the air dissipating in a line

Before starting the ignition

After one application on the brake pedal

The air tanks start full, cycled down, then back up to check for leaks

3 / 30

When must drivers incorporate the air brake pre-trip inspections?

Every two hours

Separately from other inspections

Every 48 hours

During the daily pre-trip inspection

4 / 30

What does the procedure on the Air Brake Practical Test form serve as?

Can be used while writing the test

No real purpose

A checklist for the air brake system pre-trip inspection

A guide to study from

5 / 30

Which statement is false? Why conduct a post-trip air brake inspection?

Ensure the foundation brakes have maintained adjustments

Confirm the foundation brakes have overheated

Open the drain valves on the tanks to allow the tanks to drain

Confirm the foundation brakes have not overheated

6 / 30

Ideally, when should the en-route inspections be done?

At the end of the trip

Every few hours

Once a day

Every few days

7 / 30

To check the automatic feature of the trailer air supply valve, which statement is false?

Push the trailer supply valve

The park control valve should be in

Turn the key to the 'run' position

Ensure the engine is turned off

8 / 30

When descending a steep hill, your brakes must be inspected...

When a green sign is located

When a yellow sign is located

When directed to by fellow drivers

When a white sign is located

9 / 30

To check the automatic feature of the park control valve, which statement is false?

Push in the park control valve

Pull out the park control valve

Park control valve should pop out by 20-45 psi

Pump the foot valve to reduce air pressure

10 / 30

During a vehicle inspection, can a vehicle be driven if it has a minor defect?

It must be placed out-of-service

Yes it can

Can be driven to the maintenance yard

No it can't

11 / 30

Which system does the Stability Control System replace?

The Antilock Brake System

The Automatic Traction Control System

The air brake system

Nothing

12 / 30

What does the Stability Control System correct?

Speed control

None of the above

Tire inflation

Unusual vehicle behaviour of the steering, brakes, rollover and jackknife

13 / 30

During the pre-hill inspection, what must be checked as a minimum brake inspection?

Brake lights on the trailer

Air brake leaks

Hydraulic brakes

Gauges

14 / 30

When should the completed inspection report be available for peace officers?

Within 7 days of asking for it

As soon as they ask for it

Within 12 hours of asking for it

Within 48 hours of asking for it

15 / 30

During an en-route air brake inspection during the shift, which statement is false?

Check that the trailer air line couplers are still firmly connected and suspended

Pull the supply tank drain lanyard to check for any moisture

Confirm the ABS system is working

Confirm that the foundation brakes are not overheating

16 / 30

Which statement is false? The purpose of the Commercial Vehicle Safety Regulation of the Traffic Safety Act is...

Reduces the chance of a collision caused by mechanical failure

Provides minimum standards for trip inspections

Ensures the air brake system is in a safe operating condition

17 / 30

During the pre-hill brake inspection, which statement is false?

Ensure the compressor has some air and is not dropping too much

Check brake temperature

Check the air system for leaks

Check the security of trailer air lines

18 / 30

Which is not an air brake major defect?

Air pressure loss rate exceeds the proscribed limit

Low air pressure warning system fails or activates

Checking the park brake and it operates

Tractor protection system malfunction in towing vehicles

19 / 30

While regulations govern the legislative requirements for vehicle inspections, how often do industry best practices require vehicles to be inspected?

Roadside inspections

The pre-trip and the post trip inspections

Just the pre-trip inspection

Often throughout the shift

20 / 30

If a wheel spin is detected by the ATC system, what happens?

It applies the wheel's brake, slowing the wheel spin

It locks the spinning wheel

It slows down that wheel and the pairing wheel

It slows down all the wheels on that side of the vehicle

21 / 30

When should the commercial vehicle inspection report be submitted to the carrier?

Within 20 days

Within 24 hours

Within 14 days

Within 7 days

22 / 30

During the Tractor Protection System, low air pressure warning should turn on by what psi?

60 psi

30 psi

40 psi

50 psi

23 / 30

Which is tested with the engine running?

The supply circuit

Tractor protection system

Park Control Valve

Air system leaks

24 / 30

If any new items were added to the vehicle after the daily inspection, what happens?

Just add it and move on

Nothing

It should be ignored until the next daily report is done

It should be inspected and written down on the Trip Inspection Report prior to its use

25 / 30

When performing the air brake inspection during the daily inspection, when should the trailer be inspected?

After coupling and the trailer is charged

After the trailer is driven one vehicle length

Before the trailer is coupled to the tractor

None of the above

26 / 30

During the Tractor Protection System, the trailer air supply valve should pop out at what psi?

60-80 psi

80-100 psi

20-30 psi

70-90 psi

27 / 30

The ATC has a dashboard light that illuminates at certain times? What does it mean if it flashes?

The ATC system is activated

The ATC is only partially working

There is a problem with the ATC system

It's a self-test

28 / 30

What is a minor defect with the air brake system?

Low air pressure in the primary tank

Audible air leaks and slow air pressure build-up

None of the above

Low air pressure in the secondary tank

29 / 30

What does the driver need to do differently with a vehicle equipped with the Stability Control System?

Nothing

Learn to have a greater feel of the accelerator

Learn to listen to sounds coming from the vehicle

Learn to have a greater feel of the brake pedal

30 / 30

Which systems are more advanced?

Automatic Traction Control Systems

Stability Control Systems

They are all equal

Anti-lock Brake Systems

Your score is

By WordPress Quiz plugin

Alberta Air Brake Test 07

About

Practice Tests

Getting a License

Get In Touch