Ontario Truck Driver Test 02

Taking the Ontario Truck driver’s licence practice test can be a highly effective way to prepare for the real exam. This test is designed to mimic the same difficult questions, format and time constraints as the actual exam. There are four key areas of knowledge that are tested; road signs, safe driving practices, driving laws and regulations, and truck inspection and maintenance protocols. It is important to note that in Ontario, all truck drivers are required to hold a particular type of driver’s licence depending on their vehicle’s weight. Once a driver has successfully completed the practice test and has accumulated enough knowledge and training to pass the real exam, they will be licensed to transport goods or passengers in a safe and responsible manner. Taking the Ontario truck driver’s licence practice test is an excellent way to set oneself up for success and to ensure that their career in trucking is both profitable and fulfilling.

1 / 30

Which statement is false? The driver shall re-inspect the vehicle's cargo and the cargo securement systems, and adjust at intervals, based on whichever of the following occurs first...

The vehicle has been driven for 240 km

There is a change of duty status of the driver

The vehicle has been driven for three hours

The driver has reached their destination

2 / 30

What comes with an annual inspection certificate and an annual inspection record?

None of the above

An annual inspection sticker

A completion letter

A medallion

3 / 30

What is the most common reason for taking a commercial vehicle out of service?

Low compression

Broken wheel hub

Out-of-adjustment air brakes

Broken piston

4 / 30

Which statement is false? Prior to the uncoupling/coupling procedure, you must always remember...

Turn off the engine

Sound your horn before backing (electric horn only if during the road test)

Confirm the location is suitable and safe for uncoupling and coupling the truck and trailer

Roll down windows and turn off any audio systems

5 / 30

Is the daily inspection is a requirement of the Highway Traffic Act?

Only for Class A vehicles

Only for Class D vehicles

Yes

6 / 30

Which of the following is not a step for coupling a trailer for Class A?

Inspect fifth wheel, coupling device, air/electrical lines, chain hook points and connections

Unlock fifth wheel

Position truck/tractor and trailer units. Check trailer alignment and height

Engage fifth wheel and test or engage truck coupling device and trailer connection point

7 / 30

If you refuse or fail to proceed to a weigh scale when requested, you are guilty of an offence and liable to a fine and may also have your licence suspended for up to...

7 days

45 days

30 days

15 days

8 / 30

The daily inspection is conducted in accordance with what?

The company policy

Vehicle manufacturers guidelines

An inspection schedule

Driver's discretion

9 / 30

During a pre-trip inspection, when a minor defect is identified, the driver must...

Repair it

Record the defect on the inspection report and report the defect to the operator

Inform the employer

Record the defect on the inspection report and fix it

10 / 30

The front tires of a motor vehicle with a gross vehicle rating of more than 4,500 kilograms must have at least how many millimetres of tread measured in two adjacent tread grooves?

2 millimetres

2.5 millimetres

3 millimetres

3.5 millimetres

11 / 30

Which statement is false? All drivers of a commercial vehicle should carry and surrender on demand the following documents when asked at a weigh station...

A daily log for the day and the previous fourteen days

The CVOR certificate or true copy of the individual or company responsible for the driver, vehicle and its load

A daily inspection report that has been completed within 72 hours and without a copy of the appropriate inspection schedule

A valid driver's licence of the appropriate class for the vehicle being operated

12 / 30

The rear tire of a motor vehicle must not have less than how many millimetres of tread measured in two adjacent tread grooves?

1.5 millimetres

1.8 millimetres

2.5 millimetres

0.5 millimetres

13 / 30

What is another word for free-play in the steering system?

Lash

Lag

Shift

Pull

14 / 30

The industry standard colours for the air hoses are...

Black and red

Blue and red

Green and yellow

Blue and yellow

15 / 30

Are you allowed to operate a vehicle or combination of vehicles on a highway when its gross weight exceeds the maximum weight permitted?

Only for a trip of 160 km from the home base

Only within city limits

Yes

16 / 30

When do wheel manufacturers recommend having wheel fasteners re-checked?

Between 80 km and 160 km after installation

Between 40 km and 60 km after installation

They don't

Between 200 km and 280 km after installation

17 / 30

Which is not a step when disengaging the fifth wheel (fifth wheel tractor trailer only)?

Ensure the fifth wheel is not in contact with the trailer, and the tractor frame is still under the trailer

Apply tractor parking brakes and place transmission in neutral

Place the vehicle in reserve and move it back slightly

Pull the tractor forward far enough to disengage the fifth wheel

18 / 30

A driver is required to complete a vehicle inspection every...

24-hour period

12-hour period

18-hour period

48-hour period

19 / 30

What radius can the driver operate that they may be exempt from carrying a daily log, but will still be subject to all of the requirements for hours of service?

140 km

90 km

120 km

160 km

20 / 30

Who is responsible for making sure the cargo is evenly balanced and properly secured against shifting?

The carrier

The shipper

All of the above

The driver

21 / 30

What is known as hitting the pin?

Using a small sledge, loosen the pin

None of the above

Place the transmission in the lowest gear and then partially release the clutch to move the power unit in a short, sharp motion

Place the transmission in reverse and then partially release the clutch to move the power unit backward in a short, sharp motion

22 / 30

The vehicle's cargo must be inspected to ensure it is secure before driving the vehicle not more than how many km from the point where the cargo was loaded?

120 km

100 km

60 km

80 km

23 / 30

Which of the following is not a step for uncoupling a trailer for Class A?

Secure truck/tractor and trailer

Disconnect and stow air and electrical lines, safety chains or cables

Lower landing gear

Confirm fifth-wheel lock or coupling device locked

24 / 30

Which statement is false? The driver shall re-inspect the vehicle's cargo and the cargo securement systems, and adjust at intervals, based on whichever of the following occurs...

There is a change of duty status of the driver

The cargo is spread out on the trailer

The vehicle has been driven for 240 km

The vehicle has been driven for three hours

25 / 30

What is the most effective method for drivers to determine that their vehicle is in safe operating condition?

Performing a daily inspection

Repairing anything broken after it happens

Performing an annual inspection

Performing a monthly inspection

26 / 30

If a driver is directed to operate within a 160-km radius of where they start the day and return to the same location at the end of the day, they may be exempt from carrying...

A CVOR

A dangerous goods certificate

A daily log

All of the above

27 / 30

In cases where serious infractions are discovered, what happens next?

The vehicle is driven to the mechanic and they deal with it

It is reported to the vehicle owner and repaired at end of the trip

The vehicle is taken out of service

The driver can only drive within city limits

28 / 30

Which statement is false? Before lowering the landing gear, you must...

Stow the landing-gear handle (fifth wheel) in low gear

Remove the plates on the ends of the landing gear

Lower the landing gear until it is just above the ground

Check to see if the ground is level and secure

29 / 30

Which is not a step for visually checking the coupling?

Be sure the fifth-wheel release lever is in locked position and the secondary lock, if there is one, is engaged

Do a jerk test first to test the coupling

Leave the cab and look under the front of the trailer to be sure that its upper plate is resting firmly on the fifth wheel.

From behind the tractor and under the trailer, see that the jaws are completely closed

30 / 30

How much of an overhang do drivers require a red flag to be placed at the end of a load?

2.5 metres

3 metres

1.5 metres

1 metre

Your score is

Ontario Truck Driver Test 02

About

Practice Tests

Getting a License

Get In Touch